Industrial Steel Crane Beams support overhead-crane rails and repeated wheel loads. Fabrication focuses on rail-seat accuracy, bearing stiffeners, splice alignment and connection interfaces so the finished runway members can be installed and aligned efficiently.
Custom Tapered Steel Beams change depth along their length to match structural demand. They are especially effective for portal-frame rafters, tapered columns, canopies and other projects where deeper connection zones and lighter low-demand zones improve efficiency.
Custom Welded H-Shaped Steel Columns are open H-section load-bearing members fabricated from web and flange plates. Their depth, flange width, thickness, length and connection details can be optimized for building loads and grid dimensions instead of being limited to standard rolled sizes.
Custom Box Steel Columns are closed rectangular or square members fabricated from steel plates. The closed section provides strong biaxial stiffness and torsional resistance for heavily loaded frames, wide interfaces and structures where column stability is important.
Custom Cruciform Steel Columns use intersecting plates or welded H-sections to form a cross-shaped profile. The geometry distributes stiffness around two principal axes and can provide efficient support at framing intersections, architectural corners and heavily loaded column lines.
Custom Lattice Steel Columns are built-up compression members made from two or more longitudinal chords connected by lacing bars, battens or diaphragms. This open arrangement can deliver high radius of gyration and efficient load capacity for tall or widely spaced supports.
Custom Tubular Steel Columns are hollow circular, square or rectangular members fabricated or supplied to project requirements. Their closed geometry offers efficient compression behavior, clean appearance and useful resistance to torsion and buckling when correctly designed and detailed.
Custom Tapered Steel Columns change depth or width along their height to match load demand, architectural lines or portal-frame geometry. Deeper zones can be placed near bases and connections while lighter sections are used where demand is lower.
Base plates transfer column or equipment reactions into concrete foundations. They are cut, drilled, slotted, beveled and finished to approved drawings, with anchor-bolt layouts, leveling details and stiffeners coordinated for site installation.
Gusset plates connect braces, truss members and frame components at engineered nodes. Finished plates can include bolt holes, slots, copes, bevels, weld tabs and identification marks for accurate field assembly.
Custom Steel Connection Plates are finished interface components used to join beams, columns, braces and secondary steelwork. Hole groups, end geometry, plate thickness, weld preparation and match marks are produced from coordinated connection drawings.
Custom Steel Stiffener Plates reinforce webs, flanges, beam ends and column joints where local buckling or concentrated forces require additional capacity. Plates are supplied as finished, cut and prepared parts or welded subassemblies.
